FUTURA RF

RF Excited CO – Laser

 Introduction

RF Excited CO2 Fractional Laser System fires a laser beam which is then split into numbers of microscopic super fine beams, producing tiny dot, or pixel – like treatment zones within the selected target area of the skin, leaving the other zones within it perfectly intact. Therefore, the heat of laser only passes deeply through the fractional damaged area. This allows the skin to heal much faster than if the whole area was treated. During the skin self – resurfacing, a great amount of collagen is produced for skin rejuvenation, eventually the skin will look much healthier and younger.

Skin with problems before treatment
Fractional laser works on the skin
Thousands of micro –thermal zones are produced to activate skin resurfacing
More collagen is produced during self – resurfacing
   
 Application
  • Skin renewing and resurfacing

  • Wrinkle removal, Skin tightening

  • Acne and Acne Scar removal

  • Smooth burnt Scars and Surgery Scars etc.,

  • Remove intractable chloasma and pigmentation

  • Sun damage recovery.

 Advantages
  • Intelligent Laser Control System ensures a precise treatment

  • RF – exited CO2 laser energy shooting is an even steady and safe.

  • Wide range application & effective

  • Easy and Fast treatment.

  • Large – sized colorful touch screen, with maniable handpiece..

 Comparison of RF Excited CO2 & Glass Tube CO2
 
  RF Excited CO2 Glass Tube CO2
Laser source  Metal tube(from U.S.A) Glass tube
Life time 20,000 h 2,000 h
Dot Size 0.1mm (Diameter) 0.2-0.3mm (Diameter)
Cooling system Fan cooling , 
No need distilled water
Water cooling, Need distilled water.

General Specification   Wavelength 10.6 Ám, far – infrared laser
Aiming beam Less than 2 mW, red semiconductor laser
Scan mode    Laser energy 5 – 45 mJ, step value 5mJ (RF Excited CO2 laser)
Figure option 1. Square or Rectangle, min 3 X 3mm; max 20 X 20mm, step value 1mm.
2. Round, Min 3mm (diameter), Max 20mm
(diameter), step value 1mm
3. Ellipse, Min 3 X 8mm, Max 15 X 20mm,
Step value 3mm
4. Customized – Draw any shape you need and make scan.
Energy repeat 1-5 (When increasing energy repeat, laser
Energy is increased synchronously, max total energy 225mJ)
Dot Density Mode 36/49/64/100/144/225 dots in 1 cm2 Normal, Scan sequentially line by line.
Random, scan randomly, to decrease
thermal accumulation
Ultra mode Laser energy 5 – 45 mJ, adjustable.
Figure option Square, round, ellipse and customized
(max is 10 X 10 cm)
Dot repeat 1 - 5, adjustable.
Dot Density  2500(dot/cm2), fixed.
Mode Sequential & Random.
Normal Mode
 
 

 
 
Laser energy 1 – 30W, step value 1 W
Ultra Pulse (super) 1. Average power: 1 W ~ 30 W; 2. Pulse
Frequency: 300 Hz ~ 950Hz  optional
Pulse 1.Average power: 1W ~ 30 W; 2. pulse Duration: 0.1s ~1s optional
Continuous wave  1w ~ 30w
Repeat 1.Average power: 1w~30w; 2.Pulse
Dimension   50X60cmX100cm
Weight   50kg


   1 2

HOME    |    ABOUT US    |    PRODUCTS    |    CUSTOMER SERVICE    |    MEDIA CENTER    |    CONTACT US    |    ENQUIRY    |    DISCLAIMER    |    SITEMAP